Front Brake - Inspection
13-5parts diagramInspection
WARNING
Do not use an air hose to blow the brake assembly clean. Use the vacuum cleaner, to avoid breathing brake dust.
CAUTION
• Do not spill brake fluid on the car; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
• To prevent spills, cover the hose joints with rags or shop towels.
• Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
• Before reassembling, check that all parts are free of dust and other foreign particles.
• Replace parts with new ones whenever specified to do so.
• Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
• Do not mix different brands of brake fluid as they may not be compatible.
• Do not reuse the drained fluid.
NOTE
• Coat piston, piston seal, and caliper bore with clean brake fluid.
• Replace all rubber parts with new ones whenever disassembled.
Component Location
1CALIPER BRACKET()
2PAD RETAINERS()
3INNER SHIM A()
4INNER SHIM B()
5WEAR INDICATOR()
6BRAKE PADS()
7PAD SHIM()
8PIN BOOT()
9SLEEVE BOOT()
10CALIPER BODY()
11SLEEVE()
12PISTON()
13PISTON SEAL()
14PISTON BOOT()
15PIN()
| Specification | Value |
|---|---|
| Pin | 50N·m |
| Caliper bracket bolt (12 x 1.25 mm) | 78N·m |
| Caliper mounting bolt (12 x 1.25 mm) | 50N·m |
| Bleed screw | 9N·m |
Pin
50N·m
Caliper bracket bolt (12 x 1.25 mm)
78N·m
Caliper mounting bolt (12 x 1.25 mm)
50N·m
Bleed screw
9N·m