Windshield Molding

14-17prose procedure

13
Use suction cups to hold the glass over the opening, align it with the marks made in step 6 and set it down on the adhesive. Lightly push on the glass until its edges are fully seated on the adhesive all the way around.
Do not open or close the doors until the adhesive is dry.
14
Scrape or wipe the excess adhesive off with a putty knife or gauze.
Use a shop towel dampened with alcohol or unleaded gasoline to remove adhesive from a painted surface or glass.
15
After the adhesive is dry, spray water over the glass and check for leaks. Mark leaking areas and let the glass dry, then seal with sealant.
Let the car stand for at least 4 hours after glass installation. If the car has to be used within the first 4 hours, it must be driven slowly.
16
Reinstall all remaining removed parts.

Removal

1
To remove the front windshield molding, first remove the:
Do not damage the painted surface during removal procedure.
2
Cut the top rubber portion off the side of molding as shown.
3
Cut the side rubber portion off the molding as shown.