Charging System - Alternator Overhaul
16-61parts diagramAlternator Overhaul
NOTE
It is only necessary to separate the pulley, drive end housing and rotor when the front bearing needs replacement.
To remove the pulley and rotor, use 10 mm and 22 mm box wrenches to loosen the pulley locknut. Use an impact wrench to remove the nut if necessary.
CAUTION
Do not get grease or oil on the slip rings.
Parts Diagram
Diagram image not available
| Specification | Value |
|---|---|
| Pulley locknut | 115N·m |
Pulley locknut
115N·m